NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 20 445
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
1010 MESSAGE: The PSI received a bad command from the driver.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1011 MESSAGE: PSI received a bad DMA command from the driver.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1012 MESSAGE: Unknown PSI module dependent hard error.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1013 MESSAGE: The PSI detected a bad length count during download.
CAUSE: Either the download file is corrupt, or there is an incorrect
version of the download file.
ACTION: Replace the download file from your latest system update tape.
You should also check the version of the download file with NMMAINT and
call your Hewlett-Packard representative if incorrect.
1014 MESSAGE: PSI detected a bad checksum during download.
CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.
1015 MESSAGE: PSI received download blocks out of sequence.
CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.