NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 20 451
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
1046 MESSAGE: Attempting to find I/O Services message on port failed.
CAUSE: The system rejected an attempt by the driver to locate message
frames on its own port. Memory data corruption may have occurred.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1047 MESSAGE: Attempted impossible state after a request or completion.
CAUSE: The driver attempted to enter a state which it should never be
able to get into, and ceased operations instead. Memory data
corruption, a driver bug, or a problem with the execution priorities of
the driver and/or its hardware may exist.
ACTION: This problem should produce a dump. Keep the raw dump
along with the error information displayed on the console, call your
Hewlett-Packard representative, and submit an CR.
1048 MESSAGE: Driver notified of powerfail by system.
CAUSE: The driver was notified that power returned after a power
failure of any duration.
ACTION: The driver is not capable of recovering from power failures,
and modem connections were probably lost. Restart the link.
1049 MESSAGE: Request received when driver broken.
CAUSE: The driver had to reject a request message because it had
previously become broken for another reason. The rejected request
could not be processed while the driver was broken.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1050 MESSAGE: Request received when driver dead.
CAUSE: The driver received a request message during a short time
interval after shutdown completed, but before the driver’s port had
been destroyed by the system. The driver should not be receiving new
requests after shutdown, and it cannot successfully complete them.
ACTION: If this problem occurs repeatedly, call your Hewlett-Packard
representative.
1051 MESSAGE: Request received when hardware in bad state.
CAUSE: Hardware was not ready to process a request message which
required hardware participation.
ACTION: Retry the request at a later time. If the problem persists, call
your Hewlett-Packard representative.
1052 MESSAGE: Not enough TARs available to process request.
CAUSE: The driver could not obtain enough context storage to begin
processing a request, so the request was rejected. Unexpected use of