NS3000/iX Error Messages Reference Manual (36923-90043)

458 Chapter20

LAP-B Link Error Messages

LAP-B Link Shutdown Error Messages

This section describes error messages that might occur when you are

shutting down a LAP-B link. These messages appear when a

NETCONTROL STOP command calls the WAN_Kill_Module and

encounters an error. They are displayed on the HPe 3000 operator’s

console inq the following format:

WAN KILL MODULE (linkname) Message text

WAN KILL MODULE (linkname) Error ErrorNum, Status = Status,

Path: PhysPath

51 MESSAGE: Could not stop trace.

CAUSE: Trace may have been turned off via the LINKCONTROL command,

but the link software status indicates that it was on.

ACTION: Ignore this problem unless you are experiencing other

problems. Otherwise record the error information printed on the

console and contact your Hewlett-Packard representative.

52 MESSAGE: The link is not in the link table.

CAUSE: The link speciﬁed is not active.

ACTION: If the link name is incorrect, issue the command again with

the correct linkname. If the link name is correct, the link has already

been shutdown and no action is necessary.

53 MESSAGE: The link type is not SDLC, LAP-B, or RJE.

CAUSE: The caller of this module did not set the link type to one of

SDLC, LAP-B, or RJE.

ACTION: Please record the error information printed on the console and

contact your Hewlett-Packard representative.

54 MESSAGE: Could not delete the link from the link table.

CAUSE: The link name speciﬁed is not in the link table.

ACTION: Check that the link name is correct and try again. The link

may have already been shutdown.

55 MESSAGE: Could not unconﬁgure the link from the system.

CAUSE: The I/O subsystem does not have any record of this link being

active.

ACTION: Check that the link name is correct and try again. The link

may have already been shutdown.