NS3000/iX Error Messages Reference Manual (36923-90043)

476 Chapter21
Logging Location Codes
ARP Logging Location Codes
54 CLAS0002 MESSAGE: None
CAUSE: Unable to create object for ARP port data area.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
55 CLAS0002 MESSAGE: None
CAUSE: Failed to locate ARP’s ICS filter routine in NL.PUB.SYS.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
56 CLAS0002 MESSAGE: None
CAUSE: Failed to locate ARP’s timer routine in NL.PUB.SYS.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
57 CLAS0002 MESSAGE: None
CAUSE: Failed to locate ARP’s port procedure in NL.PUB.SYS.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
58 CLAS0002 MESSAGE: None
CAUSE: Unable to create the ARP port.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
59 CLAS0002 MESSAGE: None
CAUSE: LAN_STATION_ADDRESS did not return the local station address
for the link.
ACTION: Issue LINKCONTROL command on the link. Verify that the
station address is valid. If the station address is valid, see Appendix A ,
“Submitting a CR,” of this manual.
60 CLAS0002 MESSAGE: None
CAUSE: MAP_DEL_ENTITY failed due to an internal error in MAP.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
61 CLAS0002 MESSAGE: None
CAUSE: Unable to send terminate message to the Control Process.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
62 CLAS0002 MESSAGE: None
CAUSE: Received an unexpected message during the ARP module
termination.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
64 CLAS0002 MESSAGE: None
CAUSE: Unable to read ARP’s configuration data.