NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 489
Logging Location Codes
Control Process Logging Location Codes
restart the network. If the problem persists, see Appendix A ,
“Submitting a CR,” of this manual.
238 CLAS0002 MESSAGE: INTERNAL ERROR: Configuration file error
CAUSE: During NETCP processing of a network start or update
command, after an earlier successful validation of the NMCONFIG file
a later validation of the file failed (PARM = 16-bit result code returned
by the call to validatenetxport).
ACTION: The specified network was not started. Possibly the
NMCONFIG file was being modified while networks were running, and
the changes made were incomplete or incorrect. Stop Transport and use
NMMGR to open and validate the NMCONFIG configuration file and
find any errors. Correct the errors and validate again. Then restart the
network.
241 CLAS0002 MESSAGE: INTERNAL ERROR; Port
CAUSE: During later phases of its initial startup, NETCP was unable to
create a process port for itself (PARM = 32-bit status returned by the
call to create_port).
ACTION: The transport was not started. There is a problem with the
operating system or a bug in NETCP; see Appendix A , “Submitting a
CR,” of this manual.
242 CLAS0002 MESSAGE: INTERNAL ERROR; Configuration file error
CAUSE: During later phases of its initial startup, after NETCP was
finished using the NMCONFIG file, it encountered an error while
trying to close the file (PARM = 32-bit status returned by the call to
nmconfclose).
ACTION: This error in itself was not fatal, and startup continued.
However, the NMCONFIG file may be inaccessible, and to be safe
NETCP assumed it still has the file open. If Transport is later stopped,
NETCP will again try to close the file. Possibly an earlier run of
NMMGR left the file in a bad state. If the problem occurs repeatedly,
see Appendix A , “Submitting a CR,” of this manual.
251 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While creating and initializing a specific network NI because a
:NETCONTROL START command was issued, the NI module configurator
reported an error when trying to create the NI port data area or port, or
when sending an initialization message to the new NI (PARM = 32-bit
escape code returned by the call to ni_module_config). Always
preceded by another error from the module configurator (having a
different Entity number, such as 151–160), logging the reason for the
original failure.
ACTION: Record the previous error and this error. See Appendix A ,
“Submitting a CR,” of this manual.