NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 491
Logging Location Codes
Control Process Logging Location Codes
ACTION: None. This is an informative message only. The LAPB link is
now successfully engaged in protocol handshaking, and will stay up
unless an error, disconnect, or idle timeout occurs, or the network is
stopped.
259 CLAS0003 MESSAGE: INBOUND; Device disconnected
CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI link was disconnected by its
remote side (PARM = 0). May be followed by informative error 101 if
outbound data was queued when the error occurred.
ACTION: None. This is an informative error message only. NETCP will
now tell the driver on the local side to disconnect, so informative error
257 should follow.
260 CLAS0002 MESSAGE: PACKET DISCARD; Illegal phone number
CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB driver had some problem handling a
phone number change request (PARM = 32-bit NETCP device state
bitmask for the device).
ACTION: This error may be related to the syntax or length of the phone
number, but could also be caused by some internal problem. Use
NMMGR to check the syntax of the telephone number in the
NMCONFIG file for the affected link. Then attempt a :NETCONTROL
ADDLINK=linkname; NET=niname command. If the error persists, see
Appendix A , “Submitting a CR,” of this manual.
261 CLAS0002 MESSAGE: INBOUND; Device disconnected
CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that closing its LAPB PSI link failed (PARM =
16-bit internal ldev number of the device). NETCP will attempt to bring
down the device and its driver. May be followed by informative error
101 if outbound data was queued when the error occurred.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
262 CLAS0005 MESSAGE: INBOUND; INTERNAL ERROR; Async request from link
CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating its LAPB PSI link reported some sort of
miscellaneous warning (PARM = 16-bit internal ldev number of the
device).
ACTION: None. This is an informative message only.
265 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While creating an NI because a specific network was starting,
NETCP encountered an error trying to create a message pool for the
new NI port (PARM = 32-bit status returned by the call to
create_pool).