NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 503
Logging Location Codes
Control Process Logging Location Codes
ACTION: This error in itself was not fatal, and device shutdown
continued. After shutdown, use the LANDAD tool to verify the LAN
hardware is functioning correctly. If it looks good but the problem
persists, then see Appendix A , “Submitting a CR,” of this manual.
423 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While stopping an X25 network, NETCP encountered an error
attempting to delete the X25 Flow Control Manager (PARM = 32-bit
status returned by the call to netfc_kill). The Flow Control Manager
dynamically allocates the flow control buffer pools for X25.
ACTION: This error in itself was not fatal, and shutdown of the X25 NI
continued. If the error occurs every time, see Appendix A , “Submitting
a CR,” of this manual.
428 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: NETCP was about to send a level 3 restart message to the X25
protocol, but the NETCP tables showed a restart had already been sent
(PARM = 0).
ACTION: No restart message was sent this time, but this situation
should not have occurred. If it occurs repeatedly, see Appendix A ,
“Submitting a CR,” of this manual.
429 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: NETCP was about to send a level 3 stop message to the X25
protocol, but the NETCP tables showed a restart had already been sent
(PARM = 0).
ACTION: No stop message was sent this time, but this situation should
not have occurred. If it occurs repeatedly, see Appendix A , “Submitting
a CR,” of this manual.
431 CLAS0003 MESSAGE: Level 3 Down on DTC
CAUSE: NETCP received an SDI async event message informing it that
the X25 RLM was not ready, meaning that levels 3 and 2 have gone
down on the DTC for an X25 link already started by Transport
(PARM = 32-bit SDI status field from the message).
ACTION: None. This is an informative message only. In many cases the
DTC will recover on its own. If this does not happen, use the DTC
Manager to find the reason why levels 2/3 are not up. Once the problem
is corrected on the DTC, the host will be informed and will start using
the device.
500 CLAS0005 MESSAGE: LOGGING; Log
CAUSE: NETCP has received a message instructing it to process one of
the general :NETCONTROL commands (PARM = hex 330). Examples of
these are START, ADDLINK, DELLINK, STOP, and UPDATE commands:
anything except for STATUS.