NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 507
Logging Location Codes
Control Process Logging Location Codes
611 CLAS0002 MESSAGE: INTERNAL ERROR; Module Deconfig Failed
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP encountered an error when
trying to stop one of the general protocols (PARM = 32-bit escape code
returned by the call to the module deconfigurator that failed). Always
preceded by another error from another entity (having a different
Entity number, such as 151–160), indicating the cause of the original
failure.
ACTION: This error in itself was not fatal, and shutdown continued.
However, some system resources may be lost until the next system
restart. Inspect the previous error, and if necessary see Appendix A ,
“Submitting a CR,” of this manual.
612 CLAS0003 MESSAGE: INTERNAL ERROR; NM Entry
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP encountered an error trying to
delete the NS Registry (PARM = 32-bit status returned by the call to
reg_del_register).
ACTION: This error in itself was not fatal, and shutdown continued.
However, it may not be possible to restart Transport without first
restarting the system. If necessary, see Appendix A , “Submitting a CR,”
of this manual.
613 CLAS0002 MESSAGE: BUFFER MANAGER; Buffer manager error
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP encountered an error trying to
delete its utility buffer pool (PARM = 32-bit status returned by the call
to bmgr_delete_pool).
ACTION: This error was not fatal, and network shutdown continued.
However, the amount of system memory used by the pool may be
inaccessible until the next system restart. Probably some buffers for the
pool were lost, or are still outstanding in modules which remain in the
background after NETCP terminates. If the problem occurs repeatedly,
see Appendix A , “Submitting a CR,” of this manual.
614 CLAS0002 MESSAGE: INTERNAL ERROR; Data dictionary error
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP encountered an error trying to
delete a CM Port Dictionary entry named “NetCP”, into which it had
stored its own port number, for use by various CM transport modules
such as PROBE (PARM = 16-bit result code returned by the call to
dict_delete). The CM Port Dictionary is an operating system lookup
service used by, but not part of, Transport.
ACTION: This error in itself was not fatal, and shutdown continued.
However, it may not be possible to restart Transport without first
restarting the system, since if the Dictionary entry does still exist,