NS3000/iX Error Messages Reference Manual (36923-90043)

510 Chapter21
Logging Location Codes
Control Process Logging Location Codes
620 CLAS0002 MESSAGE: Bad status
CAUSE: While attempting to send a device start message to an existing
NI in response to a :NETCONTROL command, NETCP encountered an
error on the send (PARM = 32-bit status returned by the call to
send_msg).
ACTION: The device was started at the NETCP and MAP layers, but not
at the NI layer. As a result, no packets can be successfully sent or
received over that device, and other errors, especially NI errors, may
occur if attempted. Restart the network. If the problem persists, see
Appendix A , “Submitting a CR,” of this manual.
621 CLAS0002 MESSAGE: Bad status
CAUSE: After successfully starting an FDDI link and all its network
specific protocols because a :NETCONTROL START command was issued,
NETCP encountered an error trying to send a broadcast information
message to the UDP protocol module (PARM = 32-bit status returned
by the call to send_msg).
ACTION: This error in itself was not fatal, and NETCP startup
continued. After this failure, most of Transport, with the exception of
UDP, will probably run correctly. However, certain actions, such as Path
Verifies, can indirectly result in more sends to UDP, which may cause
more errors. When convenient, try stopping Transport using
:NETCONTROL STOP, then restart it and bring up the FDDI link again. If
the same problem persists, see Appendix A , “Submitting a CR,” of this
manual.
622 CLAS0002 MESSAGE: Bad status
CAUSE: While attempting to send a DCN start message to IPU in
response to an X25 automatic restart or a user’s :NETCONTROL START or
:NETCONTROL ADDLINK command, NETCP encountered an error on the
send (PARM = 32-bit status returned by the call to send_msg). A DCN
start message is required for a Directly Connected Network such as
X25.
ACTION: IPU did not receive the message, so it does not know the
network is started. As a result, path resolution for the NI will fail.
Restart the network. If this problem continues, see Appendix A ,
“Submitting a CR,” of this manual.
623 CLAS0002 MESSAGE: Bad status
CAUSE: After completing construction of a GATEWAY update buffer in
response to startup or shutdown of some network, NETCP encountered
an error trying to send a message referencing that buffer to the IPU
module of Transport (PARM = 32-bit status returned by the call to
send_msg).
ACTION: IPU did not receive the message, so path resolution
information for the network will not be up to date, and attempts to