NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 519
Logging Location Codes
Control Process Logging Location Codes
restarting the network. If the problem persists, see Appendix A ,
“Submitting a CR,” of this manual.
650 CLAS0002 MESSAGE: INTERNAL ERROR; Module Deconfig Failed
CAUSE: During the final phases of shutdown because of a :NETCONTROL
STOP command or a system shutdown, NETCP encountered and error
while attempting to stop the ICMP Server module it previously started
(PARM = 32-bit status returned by the call to
icmp_server_module_deconfig).
ACTION: This error in itself was not fatal, and shutdown continued.
However, any system resources owned by the ICMP Server may be lost
until after the next system restart. If this problem occurs repeatedly,
see Appendix A , “Submitting a CR,” of this manual.
651 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,
NETCP encountered an error trying to start the TCP protocol module
(PARM = 32-bit status returned by the call to tcp_module_config).
Always preceded by another error from another entity (having a
different Entity number, such as 151–160), logging the reason for the
original failure.
ACTION: None of the general protocols were started, so Transport will
not work. Older versions of Transport will improperly continue the
startup after this error, and may also hang when stopped. Record the
previous error and this error. Stop the network, if there is no hang, then
try restarting the network. If the problem persists, see Appendix A ,
“Submitting a CR,” of this manual.
652 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,
NETCP encountered an error trying to start the UDP protocol module
(PARM = 32-bit status returned by the call to tcp_module_config).
Always preceded by another error from another entity (having a
different Entity number, such as 151–160), logging the reason for the
original failure.
ACTION: Some of the general protocols were started, but Transport will
not work. Older versions of Transport will improperly continue the
startup after this error, and may also hang when stopped. Record the
previous error and this error. Stop the network, if there is no hang, then
try restarting the network. If this problem persists, see Appendix A ,
“Submitting a CR,” of this manual.
653 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,