NS3000/iX Error Messages Reference Manual (36923-90043)

530 Chapter21
Logging Location Codes
Control Process Logging Location Codes
operate correctly. Verify you have all the required patches, especially a
coherent set of patches required to support 2048 X25 SVC paths under
NMMGR and NS Transport. Also verify that the number of X25 paths
configured in the NMCONFIG file is within the supported limits. If the
problem still cannot be found, see Appendix A , “Submitting a CR,” of
this manual.
688 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: While starting or updating a ROUTER network, because a
:NETCONTROL command was issued, NETCP successfully started a
LAPB link device, then encountered an error trying to read information
from the NMCONFIG file about the number of mappings in that NI,
prior to actually loading the mappings (PARM = 32-bit status returned
by the call to nmconf3soninfo).
ACTION: No mapping entries were read, and though network startup
probably continued to completion without a command error, you will
not be able to connect to any remote nodes configured in the mapping
entries. Verify you have a coherent set of patches installed, especially
between Transport and NMMGR, and especially if your NMCONFIG
file contains a large number of ROUTER mappings. Try stopping and
restarting the network. If the problem persists, you may have a
software installation problem, a bug in the NMS subsystem, or a
corrupt NMCONFIG file; if necessary, see Appendix A , “Submitting a
CR,” of this manual.
689 CLAS0002 MESSAGE: Module Deconfig Failed
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP encountered an error trying to
delete the NETIPC Socket Registry module (PARM. (0:16) = error
location within SOCKREG.NET.SYS and PARM. (16:16) = error status
from SOCKREG).
ACTION: This error in itself was not fatal, and shutdown continued.
However, depending on the error it may not be possible to restart
Transport without first restarting the system. See Appendix A ,
“Submitting a CR,” of this manual.
690 CLAS0002 MESSAGE: Data dictionary error
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, after attempting to delete the NETIPC
Socket Registry module, NETCP discovered a CM Port Dictionary entry
named "SOCKREGISTRY" had not been deleted (PARM = 32-bit port
number of the SOCKREG.NET.SYS process which failed to delete the
entry).
ACTION: This error in itself was not fatal, and shutdown continued.
However, the entry should have been deleted, and now it will not be
possible to restart Transport without first restarting the system. See
Appendix A , “Submitting a CR,” of this manual.