NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 537
Logging Location Codes
NS Configurator Logging Location Codes
manual.
17 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating a message port for the module,
an error occurred while trying to release ownership of the port (PARM =
32-bit status returned by the call to port_control).
ACTION: There may be a problem with the Ports subsystem of MPE or a
bug in the Module Configurator. See Appendix A , “Submitting a CR,” of
this manual.
18 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating a message port for the module
and sending other messages to it, an error occurred while trying to send
a Bind message (PARM = 32-bit status returned by the call to
send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE or a
bug in the Module Configurator. See Appendix A , “Submitting a CR,” of
this manual.
19 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to destroy a protocol module attached
to an NI, or the NI itself, an error occurred while trying to send a
termination message to the module (PARM = 32-bit status returned by
the call to send_msg).
ACTION: Resources allocated to the module were not released. There
may be a problem with the Ports subsystem of MPE, a bug in the
Module Deconfigurator, or the modules port may be full. If this problem
occurs every time, see Appendix A , “Submitting a CR,” of this manual.
20 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to unbind or destroy a protocol
module attached to an NI, after successfully sending a termination
message to the module and awaiting a reply message, the reply received
was not a termination reply (PARM = 0).
ACTION: Resources allocated to the module were not released. Another
module may have unexpectedly sent a message to the reply subqueue of
NETCP’s Transport port, or the module which received the termination
message may be confused. If this problem occurs every time, see
Appendix A , “Submitting a CR,” of this manual.
21 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to destroy a protocol module attached
to an NI, after successfully sending a termination message to the
module and awaiting a reply message, a reply was received but the