NS3000/iX Error Messages Reference Manual (36923-90043)

540 Chapter21
Logging Location Codes
CX Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
10 CLAS0003 MESSAGE: None
CAUSE: A port for communication between the CI and CT server process
could not be created.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
11 CLAS0002 MESSAGE: None
CAUSE: A port DST entry could not be allocated for the port between the
CI and VT server.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
12 CLAS0003 MESSAGE: None
CAUSE: The VT service could not be initiated.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
13 CLAS0003 MESSAGE: None
CAUSE: A port message with an unexpected function code was received
from the VT server process.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
14 CLAS0002 MESSAGE: None
CAUSE: The VT server process could not be created.
ACTION: If the DSSERVER.NET.SYS program is missing, restore it from
the NS product tape. If there are no DSSERVERs running, then try to
run DSSERVER.NET.SYS to see if there are any loader errors. Wait for
the number of DSSERVERs to decrease, or increase the maximum
number of DSSERVERs by NSCONTROL SERVER = DSSERVER,,wmax.
(Only users with NM capability can use the NSCONTROL command.) See
Appendix A , “Submitting a CR,” of this manual.
15 CLAS0002 MESSAGE: None
CAUSE: The local VT sever (VTL) has not been started via an
NSCONTROL command.
ACTION: Issue NSCONTROL START or NSCONTROL START=VTL to start the
local service, or wait until the service is started. (Only users with NM
capability, who also have ALLOW capability, can use the NSCONTROL
command.)
16 CLAS0003 MESSAGE: None
CAUSE: An NSCONTROL ABORT has been issued.
ACTION: Issue NSCONTROL START, or wait until the service is started.
(Only users with NM capability, who also have ALLOW capability, can
use the NSCONTROL command.)