NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 541
Logging Location Codes
CX Logging Location Codes
18 CLAS0002 MESSAGE: None
CAUSE: A port message with the remote command could not be sent
from the CI to the VT server process.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
19 CLAS0003 MESSAGE: None
CAUSE: A port message send to DSDAD failed.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
21 CLAS0003 MESSAGE: None
CAUSE: The DSLINE JCW, set to the DSLINE number by the NS software,
could not be found.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
22 CLAS0003 MESSAGE: None
CAUSE: Not enough stack space to execute the NS command.
ACTION: Prepare or link the program with more stack space.
23 CLAS0003 MESSAGE: None
CAUSE: Internal resource problem. Could not get DST for NSCONTROL
status command.
ACTION: If this happens all the time then see Appendix A , “Submitting
a CR,” of this manual.
24 CLAS0003 MESSAGE: None
CAUSE: Internal resource error. Server terminated during
VT_START_UP.
ACTION: Reissue the command. If it happens again see Appendix A ,
“Submitting a CR,” of this manual.