NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 543
Logging Location Codes
DC/LDM Logging Location Codes
ACTION: No message was sent, so the CM module may not be aware any
problem has occurred. This may affect other operations on the network.
See Appendix A , “Submitting a CR,” of this manual.
17 CLAS0000 MESSAGE: Invalid CM request received in current state
CAUSE: During error processing of an invalid write event, DC/LDM
discovered the message it was working on was not a write event
message.
ACTION: The message should have been a write event, so this indicates
an internal bug in DC/LDM. See Appendix A , “Submitting a CR,” of
this manual.
18 CLAS0000 MESSAGE: Send_msg error while issuing NM reply
CAUSE: While attempting to send an error reply message back to the
sender of an earlier Native mode trace request or HLIO request, the
system routine send_msg reported an error.
ACTION: No message was sent, so the sender may not be aware any
problem has occurred. This may affect other operations on the network.
DC/LDM is still operating. See Appendix A , “Submitting a CR,” of this
manual.
19 CLAS0000 MESSAGE: Invalid NM request received in current state
CAUSE: In attempting to send an error reply message for an earlier
HLIO request, DC/LDM hit a bug because that request was not
understood by the code which sends the replies.
ACTION: The request should have been understood, so this indicates an
internal bug in DC/LDM. No message was sent, so the sender may not
be aware any problem has occurred. This may affect other operations on
the network. DC/LDM is still operating. See Appendix A , “Submitting
a CR,” of this manual.
20 CLAS0000 MESSAGE: Invalid event received in current state
CAUSE: An invalid event message was received by DC/LDM. Events
cannot be replied to, but this logs the bad state DC/LDM was in at the
time the event was received.
ACTION: If this was a read event, its buffer was freed; otherwise the
event message was ignored. DC/LDM is still operating. See Appendix
A , “Submitting a CR,” of this manual.
22 CLAS0000 MESSAGE: Error in releasing CM request write buffer
CAUSE: During error processing of an invalid write event, DC/LDM
encountered another error while trying to free the BMGR buffer
referenced by the bad write request message, but the system routine
bmgr_free_buffer reported an error.
ACTION: DC/LDM will continue operating, but if this situation
continues, the network may run out of buffers. In addition, any