NS3000/iX Error Messages Reference Manual (36923-90043)

546 Chapter21
Logging Location Codes
DC/LDM Logging Location Codes
manual.
CAUSE: While flushing its port subqueues, DC/LDM found an I/O
request message on its port having a nonzero buffer ID, but when
trying to free the BMGR buffer referenced by that message, the system
routine bmgr_free_buffer reported an error.
ACTION: DC/LDM will continue stopping, but if this situation
continues, the network may run out of buffers. In addition, any
subsequent network shutdown may hang. See Appendix A ,
“Submitting a CR,” of this manual.
40 CLAS0000 MESSAGE: Error encountered in configurator module
CAUSE: While starting the DC/LDM, an error occurred when adding a
CM Port Dictionary entry, reading the LSS link table, loading a
manager plabel, allocating an HLIO device, creating an LDM port,
adding a device, sending a message, or changing a port subqueue.
ACTION: DC/LDM did not start. See Appendix A , “Submitting a CR,” of
this manual.
CAUSE: While stopping the DC/LDM, an error occurred when deleting a
CM Port Dictionary entry or HLIO device, when releasing a device, or
because of a bad DC/LDM state.
ACTION: DC/LDM continued stopping, but this could indicate a more
serious problem in the High Level I/O system or the DC/LDM. If the
problem occurs every time, see Appendix A , “Submitting a CR,” of this
manual.
CAUSE: While flushing its port subqueues, DC/LDM found a read event
message on its port having a nonzero buffer ID, but when trying to free
the BMGR buffer referenced by that message, the system routine
bmgr_free_buffer reported an error.
ACTION: DC/LDM will continue operating, but if this situation
continues, the network may run out of buffers. In addition, any
subsequent network shutdown may hang. See Appendix A ,
“Submitting a CR,” of this manual.