NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 551
Logging Location Codes
Dial ID Logging Location Codes
41 CLAS0002 MESSAGE: None
CAUSE: An acknowledgment packet was received but the Dial ID
protocol was not in the correct internal state to receive an ack (PARM =
state of the Dial ID protocol)
ACTION: See Appendix A , “Submitting a CR,” of this manual.
42 CLAS0002 MESSAGE: None
CAUSE: The sequence number of an acknowledgment packet does not
match sequence number sent in the reply packet. Either the
acknowledgment packet has been corrupted or the remote node is not
responding correctly to the Dial ID reply packet (PARM = sequence
number received in the ack message).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
43 CLAS0006 MESSAGE: None
CAUSE: Dial ID is logging statistics prior to its port termination.
ACTION: Informational message.
44 CLAS0002 MESSAGE: None
CAUSE: There is no matching internal Dial ID queue element for the
device in which an acknowledgment packet was just received (PARM =
index of device).
ACTION: It is possible that if the remote node is heavily congested the
queue element can be deleted before the late packet arrives. This can be
considered normal. If the problem does not appear to be related to this,
then see Appendix A , “Submitting a CR,” of this manual.
45 CLAS0002 MESSAGE: None
CAUSE: There is no matching internal Dial ID queue for the device in
which a reply packet was just received (PARM = index of device).
ACTION: It is possible that if the remote node is heavily congested the
queue element can be deleted before the late packet arrives. This can be
considered normal. If the problem does not appear to be related to this
then see Appendix A , “Submitting a CR,” at the beginning of this
manual.
46 CLAS0002 MESSAGE: None
CAUSE: A call to the internal procedure PDX'NAME'CACHE failed.
ACTION: None.
47 CLAS0002 MESSAGE: None
CAUSE: The security string contained in the remote node’s reply packet
does not match any of the strings configured at the local node.
ACTION: Verify that the security string configured under the Dial ID