NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 569
Logging Location Codes
IP Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
111 CLAS0003 MESSAGE: None
CAUSE: The packet length carried in the IP header is greater than the
packet length supplied by the link device (PARM = upper 16 bits:
header value; lower 16 bits: actual received).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
112 CLAS0003 MESSAGE: None
CAUSE: Unable to deliver an inbound ICMP message to an upper layer
protocol (TCP/PXP) (PARM = ULP SEND result code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
113 CLAS0003 MESSAGE: None
CAUSE: Discarded an inbound ICMP message because the ICMP
checksum was bad (PARM = upper 16 bits = actual checksum; lower
16 bits = expected checksum).
ACTION: Frequent occurrences probably indicate hardware or
transmission line problems.
114 CLAS0003 MESSAGE: None
CAUSE: Discarded an inbound ICMP message because the ICMP type
code was unrecognized (PARM = ICMP type/code). To decode the PARM
value, refer to the previous section, “ICMP Type/Code Words.”
ACTION: Indicates that a non-HP e3000 node has implemented an
ICMP type not prescribed by the ICMP RFC standard.
115 CLAS0002 MESSAGE: None
CAUSE: Indicates that log calls were suppressed for performance
reasons. The following log message is the one that was suppressed
(PARM = upper 16 bits: location suppressed; lower 16 bits: number of
times suppressed).
ACTION: Informative.
116 CLAS0003 MESSAGE: None
CAUSE: Received a GGP protocol message. This is an unsupported
protocol (PARM unused).
ACTION: Informative. A non-HP e3000 node which supports the GGP
protocol is part of the network configuration.
118 CLAS0002 MESSAGE: None
CAUSE: An inbound data packet was discarded as undeliverable
(PARM = ULP SEND result code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.