NS3000/iX Error Messages Reference Manual (36923-90043)

570 Chapter21
Logging Location Codes
IP Logging Location Codes
121 CLAS0003 MESSAGE: None
CAUSE: An inbound packet was discarded because it failed IP header
validation tests (PARM not significant).
ACTION: If this occurs frequently see Appendix A , “Submitting a CR,”
of this manual.
122 CLAS0003 MESSAGE: None
CAUSE: An inbound packet was discarded because the IP header
checksum failed (PARM = upper 16 bits = actual checksum; lower
16 bits = expected checksum).
ACTION: Frequent occurrences probably indicate hardware or
transmission line problems.
123 CLAS0003 MESSAGE: None
CAUSE: An inbound data packet was discarded because an error was
detected in IP options (PARM = byte location in IP header of error).
ACTION: Check to see that the source node correctly formats the options
stream.
124 CLAS0002 MESSAGE: None
CAUSE: An inbound packet was discarded because it was not addressed
to this node and store and forward was not allowed from the inbound
network interface (PARM unused).
ACTION: Configure store and forward buffers for the IP protocol on the
inbound network interface.
125 CLAS0002 MESSAGE: None
CAUSE: An inbound message fragment was discarded because a
reassembly data structure could not be allocated.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
128 CLAS0002 MESSAGE: None
CAUSE: An inbound message fragment was discarded because it is a
retransmission of a previously received last fragment and is no longer
the last fragment (PARM is not significant).
ACTION: Indicates that someone is sending a duplicate message in error
(that is, with the same message ID) but with a longer length.
130 CLAS0002 MESSAGE: None
CAUSE: A message fragment was discarded because of an internal
failure of bmgr_append_buffer (PARM = bmgr_append_buffer result
code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.