NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 607
Logging Location Codes Continued
NI Logging Location Codes
14 CLAS0002 MESSAGE: None
CAUSE: On arrival of inbound data, a send_msg to the upper layer
protocol failed (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
15 CLAS0002 MESSAGE: None
CAUSE: The NI received an inbound data message from a device that is
not in the device table for this NI (PARM = LDEV).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
18 CLAS0002 MESSAGE: None
CAUSE: A bad or unexpected message was received by the NI (PARM =
Message Function Code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
19 CLAS0002 MESSAGE: None
CAUSE: While trying to send outbound loopback data back, a send_msg
failed (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
21 CLAS0002 MESSAGE: None
CAUSE: While trying to send outbound data to a router driver via
DC/LDM, a send_msg failed (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
22 CLAS0002 MESSAGE: None
CAUSE: Transport sent outbound data to NI for a Protocol ID which has
no match in the PID table for this NI (PARM = Protocol ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
23 CLAS0003 MESSAGE: None
CAUSE: While attempting to send outbound data, NI discovered the
route ID in the message was out of date, so the outbound packet was
discarded (PARM = route ID from route table).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
24 CLAS0002 MESSAGE: None
CAUSE: A protocol other than PROBE attempted to send a multicast
packet, disallowed by the NI (PARM = Protocol ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.