NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 609
Logging Location Codes Continued
NI Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
52 CLAS0002 MESSAGE: None
CAUSE: After receiving a connect confirmation event from a driver,
send_msg failed trying to forward a similar message to the protocol
(PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
53 CLAS0002 MESSAGE: None
CAUSE: A driver acknowledged disconnection of a link which NI could
not find in its tables (PARM = Protocol ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
55 CLAS0002 MESSAGE: None
CAUSE: After receiving a disconnect confirmation event from a driver,
NI could not find the protocol for that device type, either X.25 or SNA,
in its PID table.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
56 CLAS0002 MESSAGE: None
CAUSE: After receiving a disconnect confirmation event from a driver,
send_msg failed trying to forward a similar message to the protocol
(PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
58 CLAS0002 MESSAGE: None
CAUSE: After receiving a connect reply from a driver, send_msg failed
trying to forward a similar message to the sender of the original
connect (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
59 CLAS0002 MESSAGE: None
CAUSE: After receiving a disconnect reply from a driver, NI could not
locate information about the original request in its tables (PARM =
message ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
60 CLAS0002 MESSAGE: None
CAUSE: After receiving a disconnect reply from a driver, send_msg
failed trying to forward a similar message to the sender of the original
disconnect (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.