NS3000/iX Error Messages Reference Manual (36923-90043)

610 Chapter22
Logging Location Codes Continued
NI Logging Location Codes
63 CLAS0002 MESSAGE: None
CAUSE: While trying to send outbound data to a driver, send_msg failed
(PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
64 CLAS0002 MESSAGE: None
CAUSE: NI received inbound data from a driver, for a link which NI
could not find in its tables (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
67 CLAS0002 MESSAGE: None
CAUSE: While processing inbound data from a driver, send_msg failed
trying to forward the data to the protocol (PARM = status from
send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
68 CLAS0002 MESSAGE: None
CAUSE: CP asked NI to connect a device which NI could not find in its
device table (PARM = device ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
71 CLAS0002 MESSAGE: None
CAUSE: When attempting to create a free pool of device and protocol
entries, new_create_table failed (PARM = status from
new_create_table).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
72 CLAS0002 MESSAGE: None
CAUSE: When attempting to create a table to hold information about
outstanding X.25 requests, new_create_table failed (PARM = status
from new_create_table).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
73 CLAS0002 MESSAGE: None
CAUSE: While processing inbound data from a driver, NI was able to
locate the input device in its device table, but then could not locate the
corresponding protocol in the protocol table.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
75 CLAS0002 MESSAGE: None
CAUSE: Bad or unexpected function code received by NI port in a
control reply message from driver (PARM = function code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.