NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 611
Logging Location Codes Continued
NI Logging Location Codes
76 CLAS0002 MESSAGE: None
CAUSE: NI request table is too small to hold information for the
number of outstanding connect requests being attempted (PARM =
request ID which was not connected).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
77 CLAS0002 MESSAGE: None
CAUSE: NI request table is too small to hold information for the
number of outstanding disconnect requests being attempted (PARM =
request ID which was not disconnected).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
78 CLAS0002 MESSAGE: None
CAUSE: While trying to delete one of NI’s tables during shutdown,
delete_table failed (PARM = status from delete_table).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
79 CLAS0002 MESSAGE: None
CAUSE: After receiving a connect reply from a driver, NI could not
locate information about the original request in its tables (PARM =
message ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
80 CLAS0002 MESSAGE: None
CAUSE: Bad or unexpected function code received by NI port in a async
event message from driver (PARM = function code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
81 CLAS0002 MESSAGE: None
CAUSE: Bad or unknown message received by NI port on inbound data
subqueues (PARM = message descriptor).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
82 CLAS0002 MESSAGE: None
CAUSE: During error recovery processing of a failed disconnect request,
send_msg failed trying to report the problem back to the sender of the
original disconnect (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
83 CLAS0002 MESSAGE: None
CAUSE: During error recovery processing of a failed connect request,
send_msg failed trying to report the problem back to the sender of the
original connect (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.