NS3000/iX Error Messages Reference Manual (36923-90043)

612 Chapter22
Logging Location Codes Continued
NI Logging Location Codes
84 CLAS0002 MESSAGE: None
CAUSE: While stopping a protocol or device, or after completing an
outstanding request, NI attempted to free a request block, device or
protocol table entry, but new_release_table_entry failed (PARM =
status from new_release_table_entry).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
85 CLAS0002 MESSAGE: None
CAUSE: During error recovery following a failure during transmission
of outbound X.25 data, netfc_release failed (PARM = status from
netfc_release).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
86 CLAS0002 MESSAGE: None
CAUSE: During error recovery following a failure during reception of
inbound X.25 data, netfc_release failed (PARM = status from
netfc_release).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
101 CLAS0002 MESSAGE: None
CAUSE: When attempting to create a table to hold information about
outstanding SNA requests, new_create_table failed (PARM = status
from new_create_table).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
102 CLAS0002 MESSAGE: None
CAUSE: While starting an FDDI device, NI was unable to read the
FDDI station address.
ACTION: The station address should be available any time the FDDI
driver has been started. See Appendix A , “Submitting a CR,” of this
manual.
103 CLAS0002 MESSAGE: None
CAUSE: An attempt was made to send a packet over a LAPB link which
did not have extended addressing specified in the packet.
ACTION: Extended addressing is always required for LAPB links. See
Appendix A , “Submitting a CR,” of this manual.
104 CLAS0002 MESSAGE: None
CAUSE: After forming the extended address for an outbound LAPB
packet, NI encountered an error trying to write that address into the
packet.
ACTION: Something is wrong with the outbound buffer. See Appendix
A , “Submitting a CR,” of this manual.