NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 617
Logging Location Codes Continued
Probe Logging Location Codes
21 CLAS0002 MESSAGE: None
CAUSE: Room allocated for node name and path report is too small
(PARM = number of bytes short).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
22 CLAS0002 MESSAGE: None
CAUSE: Timer popped which has no request outstanding (PARM =
Time request ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
23 CLAS0002 MESSAGE: None
CAUSE: Received Gateway Reply message, which is not supported
(PARM = Probe message type).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
24 CLAS0003 MESSAGE: None
CAUSE: Late reply came in when cleaning up Proxy (PARM = request
ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
27 CLAS0002 MESSAGE: None
CAUSE: Message type in incoming packet is invalid.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
28 CLAS0005 MESSAGE: None
CAUSE: Retransmission has occurred (PARM = Retries until
exhausted).
ACTION: Informative message.
29 CLAS0002 MESSAGE: None
CAUSE: Attempt to cache node name failed (PARM = Length of Name).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
30 CLAS0002 MESSAGE: None
CAUSE: Attempt to cache node name failed (PARM = Length of Name).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
32 CLAS0002 MESSAGE: None
CAUSE: Attempt to map addresses failed (PARM = Path resolve error
code).
ACTION: Increase the Maximum Number of Nodes in the LAN 802.3
Network Interface screen in NMMGR. If error recurs then see
Appendix A , “Submitting a CR,” of this manual.