NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 635
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
Remote Link Manager Logging Location
Codes
1 CLAS0001 MESSAGE: None
CAUSE: RLM’s data structures are corrupted.
ACTION: See Appendix A , “Submitting a CR,”of this manual.
3 CLAS0002 MESSAGE: None
CAUSE: Send_msg procedure returned a bad status to the RLM.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
4 CLAS0002 MESSAGE: None
CAUSE: Link Error occurred in unexpected state.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
5 CLAS0002 MESSAGE: None
CAUSE: RLM could not rendezvous (“bind”) with the MCM.
ACTION: Check the LAN hardware on the HP e3000. If no problem is
found, see Appendix A , “Submitting a CR,” of this manual.
6 CLAS0001 MESSAGE: None
CAUSE: Internal state mismatch within the RLM module.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
7 CLAS0003 MESSAGE: None
CAUSE: RLM is out of internal resources.
ACTION: The operator may be attempting to bring up more than the
maximum supported DTC links. If not, then see Appendix A ,
“Submitting a CR,” of this manual.
8 CLAS0002 MESSAGE: None
CAUSE: Either the RLM or code that it invoked encountered an
unexpected trap.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
9 CLAS0002 MESSAGE: None
CAUSE: RLM could not get a buffer to send an outbound packet
(PARM = Status returned by “bmgr_get_buffer”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.