NS3000/iX Error Messages Reference Manual (36923-90043)

636 Chapter22
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
10 CLAS0003 MESSAGE: None
CAUSE: RLM could not release some internal resources (PARM =
Status returned by “new_release_table_entry”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
11 CLAS0001 MESSAGE: None
CAUSE: RLM attempted to release a resource that had already been
released.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
12 CLAS0002 MESSAGE: None
CAUSE: RLM received a connect reply message from the link that it did
not recognize.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
13 CLAS0003 MESSAGE: None
CAUSE: The DTC is not responding to the HP e3000’s connection
attempts. (i.e., The HP e3000 could not establish an AFCP link control
connection with the DTC.)
ACTION: Check state of DTC and LAN hardware. If no problem can be
found, see Appendix A , “Submitting a CR,” of this manual.
14 CLAS0001 MESSAGE: None
CAUSE: RLM’s data structures are corrupted.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
15 CLAS0002 MESSAGE: None
CAUSE: RLM could not release internal resources.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
16 CLAS0002 MESSAGE: None
CAUSE: RLM received disconnect reply that did not match any
transaction in progress.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
17 CLAS0001 MESSAGE: None
CAUSE: State mismatch within RLM’s data structures.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
18 CLAS0002 MESSAGE: None
CAUSE: RLM received an inbound data packet over a connection that is
down.
ACTION: See Appendix A , “Submitting a CR,” of this manual.