NS3000/iX Error Messages Reference Manual (36923-90043)

642 Chapter22
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
ACTION: Check status of DTC.
70 CLAS0005 MESSAGE: None
CAUSE: Link went down abnormally during shutdown.
ACTION: Check status of X.25 card on DTC.
71 CLAS0002 MESSAGE: None
CAUSE: RLM could not release a semaphore.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
73 CLAS0002 MESSAGE: None
CAUSE: RLM’s port is out of message frames.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
74 CLAS0002 MESSAGE: None
CAUSE: RLM could not release message frame.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
76 CLAS0002 MESSAGE: None
CAUSE: RLM could not get a semaphore (PARM = “netfc_get”
status).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
77 CLAS0001 MESSAGE: None
CAUSE: Internal error within RLM.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
78 CLAS0001 MESSAGE: None
CAUSE: Internal error within RLM.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
80 CLAS0001 MESSAGE: None
CAUSE: HP e3000 could open link on DTC.
ACTION: Check error messages on console to determine problem.
82 CLAS0002 MESSAGE: None
CAUSE: RLM could not release semaphore pool.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
83 CLAS0002 MESSAGE: None
CAUSE: RLM could not release semaphore pool.
ACTION: See Appendix A , “Submitting a CR,” of this manual.