NS3000/iX Error Messages Reference Manual (36923-90043)

644 Chapter22
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
exhausted.
ACTION: Contact your Hewlett-Packard representative and/or see
Appendix A , “Submitting a CR,” of this manual.
101 CLAS0002 MESSAGE: None
CAUSE: Could not obtain plabel for NL.PUB.SYS procedure
“remote_link_manager.” Possible software installation problem
(PARM = status returned by “hpgetsysplabel”).
ACTION: Check the status of the DTC.
102 CLAS0002 MESSAGE: None
CAUSE: Could not create the port for the RLM server (PARM = status
returned from “create_port”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
103 CLAS0002 MESSAGE: None
CAUSE: Could not create the port for the RLM server (PARM = status
returned from “create_port”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
104 CLAS0003 MESSAGE: None
CAUSE: Could not open AFCP protocol module (PARM = status
returned from “mcm_module_config”).
ACTION: Check X.25 and DTS Link configuration. If no problem is
found, see Appendix A , “Submitting a CR,” of this manual.
105 CLAS0001 MESSAGE: None
CAUSE: Could not send message to the RLM server. (PARM = status
returned from “send_msg”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
106 CLAS0002 MESSAGE: None
CAUSE: Could not obtain information on per process port (PARM =
status returned from “port_info”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
107 CLAS0001 MESSAGE: None
CAUSE: Error encountered while receiving information from RLM
Server (PARM = status returned by “extend_receive”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
108 CLAS0001 MESSAGE: None
CAUSE: Message received on process port if not the expected type.