NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 645
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
109 CLAS0002 MESSAGE: None
CAUSE: Link buffer size is too small.
ACTION: Check X.25 and DTC Link configuration. If no problems are
found, see Appendix A , “Submitting a CR,” of this manual.
110 CLAS0003 MESSAGE: None
CAUSE: Could not open the file NMCONFIG.PUB.SYS (PARM = status
returned by “nmconfopen”).
ACTION: Check the nmconfig.pub.sys with the program “FSCHECK”.If
no obvious problem is found, see Appendix A , “Submitting a CR,” of
this manual.
111 CLAS0003 MESSAGE: None
CAUSE: Could not read the Node Name from NMCONFIG.PUB.SYS
(PARM = status returned by “nmconfgetdata”).
ACTION: Add nodename to configuration.
112 CLAS0003 MESSAGE: None
CAUSE: RLM could not close NMCONFIG.PUB.SYS (PARM = status
returned by “nmconfclose”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
113 CLAS0002 MESSAGE: None
CAUSE: Could not create the RLM’s inbound buffer pool (PARM =
status returned from “bmgr_create_pool”).
ACTION: Check configuration file for excessive buffer configuration.
Reduce the number of buffers if possible. If no problems are found, see
Appendix A , “Submitting a CR,” of this manual.
114 CLAS0002 MESSAGE: None
CAUSE: Could not release the RLM’s inbound buffer pool (PARM =
status returned by “bmgr_delete_pool”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
115 CLAS0003 MESSAGE: None
CAUSE: RLM could not deconfigure AFCP protocol module (PARM =
status returned by “mcm_module_config”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
116 CLAS0003 MESSAGE: None
CAUSE: RLM could not release plabel for “remote_link_manager”
(PARM = status returned by “hprelsysplabel”).