NS3000/iX Error Messages Reference Manual (36923-90043)

646 Chapter22
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
117 CLAS0003 MESSAGE: None
CAUSE: RLM could not delete the RLM’s entry from the CM port
dictionary (PARM = status returned by “dict_delete”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
118 CLAS0002 MESSAGE: None
CAUSE: RLM could not create the outbound buffer pool (PARM = status
returned by “bmgr_create_pool”).
ACTION: Check configuration file for excessive buffer configuration.
Reduce the number of buffers if possible. If no problems are found, see
Appendix A , “Submitting a CR,” of this manual.
119 CLAS0003 MESSAGE: None
CAUSE: RLM could not reset subqueue mask (PARM = status returned
by “change_subqueue”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
120 CLAS0001 MESSAGE: None
CAUSE: RLM could not update port dictionary (PARM = status
returned by “dict_update”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
121 CLAS0001 MESSAGE: None
CAUSE: RLM could not update port dictionary (PARM = status
returned by “dict_update”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
122 CLAS0003 MESSAGE: None
CAUSE: RLM could not delete the outbound buffer pool (PARM = status
returned by “bmgr_delete_pool”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
123 CLAS0003 MESSAGE: None
CAUSE: RLM could purge its port (PARM = status returned by
“purge_port”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
124 CLAS0003 MESSAGE: None
CAUSE: RLM could not release its port data area object (PARM = status
returned by “release_object”).
ACTION: See Appendix A , “Submitting a CR,” of this manual.