NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 649
Logging Location Codes Continued
RFA Logging Location Codes
system operator on the local or remote system. If not see Appendix A ,
“Submitting a CR.”
10 CLAS0003 MESSAGE: None
CAUSE: RFA encountered a NetIPC error while sending an RFA
request to the remote system.
ACTION: If the user attempted to FREAD or FWRITE more than 29980
bytes of data in one FREAD or FWRITE call, then the user has reached
the resource limits of RFA. If user has enabled data compression for
RFA transfers, this limit is 29000 bytes. This error will also occur if the
system operator has brought down the network transport on the local
or remote system. If not, see Appendix A , “Submitting a CR.”
11 CLAS0003 MESSAGE: None
CAUSE: An unexpected error occurred while receiving data from the
remote system.
ACTION: This error will occur if the system operator has brought down
the network transport on the local or remote system. It can also occur if
the version of NS on the remote system is older than this system and
the user attempted to use a newly supported file system intrinsic that is
not supported by RFA on the remote system. If neither is the case then
see Appendix A , “Submitting a CR,” of this manual.
12 CLAS0003 MESSAGE: None
CAUSE: RFA was unable to completely receive all the data from a
NOWAIT FWRITE.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
13 CLAS0003 MESSAGE: None
CAUSE: While attempting to adjust a NetIPC socket, RFA encountered
an unexpected error.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
14 CLAS0003 MESSAGE: None
CAUSE: RFA could not shutdown a NetIPC socket it created.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
15 CLAS0003 MESSAGE: None
CAUSE: RFA could not connect with the RFA server on the remote
system.
ACTION: Verify that the network transport has been started on the
remote system. Verify that the remote system supports NS 3000/iX
RFA. Also verify that the remote system has started the RFA service. If
RFA is started then see Appendix A , “Submitting a CR,” of this
manual.