NS3000/iX Error Messages Reference Manual (36923-90043)

680 Chapter22
Logging Location Codes Continued
TCP Logging Locations
14203 CLAS0005 MESSAGE: None
CAUSE: A valid reset packet was received on a connection. The
connection will abort.
ACTION: Informative message. No action required. This message
normally appears because the remote connection half was terminated
abruptly by the user through an abortive IPC shutdown. Many services
use this type of shutdown. Remote abortions also occur when errors are
encountered on the remote system. In unexpected abortion situations
inspection of the remote system for indications of error is suggested.
14301 CLAS0003 MESSAGE: None
CAUSE: Connection Assurance timeout occurred for this connection. The
remote node did not respond within the configured number of CA
retries.
ACTION: Suspect remote node failure, or possible network failure.
15001 CLAS0002 MESSAGE: None
CAUSE: BMGR_CREATE_POOL returned a bad status while trying to create
the TCP control buffer pool. This would occur during network startup.
ACTION: PARM is BMGR error returned. Submit an CR.
15002 CLAS0002 MESSAGE: None
CAUSE: BMGR_DELETE_POOL returned a bad status while trying to delete
the TCP control buffer pool.
ACTION: PARM is BMGR error returned. Submit an CR.
15901 CLAS0002 MESSAGE: None
CAUSE: An unexpected escape occurred within the procedure
tcp_process_inbound or some procedural unit called by it.
ACTION: PARM is escape code of escape. Submit an CR.
15902 CLAS0002 MESSAGE: None
CAUSE: An unexpected escape occurred within the procedure
tcp_read_completor or some procedural unit called by it.
ACTION: PARM is escape code of escape. Submit an CR.
15903 CLAS0002 MESSAGE: None
CAUSE: An unexpected escape occurred within the procedure
tcp_active_open or some procedural unit called by it.
ACTION: PARM is escape code of escape. Submit an CR.
15904 CLAS0002 MESSAGE: None
CAUSE: An unexpected escape occurred within the procedure
tcp_active_open or some procedural unit called by it.