NS3000/iX Error Messages Reference Manual (36923-90043)

694 Chapter22
Logging Location Codes Continued
UDP Logging Locations
19 CLAS0004 MESSAGE: None
CAUSE: Logging the start of the UDP module (PARM = UDP’s port ID).
ACTION: Informative message.
20 CLAS0002 MESSAGE: None
CAUSE: Attempt to add UDP to the ports data dictionary failed
(PARM = Result code from the dict_add call).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
21 CLAS0002 MESSAGE: None
CAUSE: Attempt to delete UDP from the ports MPE CM dictionary
failed (PARM = Result code returned by dict_delete call).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
22 CLAS0002 MESSAGE: None
CAUSE: Attempt to delete UDP from the ports MPE CM dictionary
failed (Attempt to send the ICMP destination unreachable message to
IP failed (PARM = Result code returned by send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
23 CLAS0002 MESSAGE: None
CAUSE: Attempt to free an inbound buffer due to a shutdown pending
failed (PARM = Status returned by bmgr_free_buffer).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
24 CLAS0002 MESSAGE: None
CAUSE: Attempt to free an inbound buffer, because there is no more
room in the IPC buffer array, failed (PARM = Result code from
bmgr_free_buffer).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
25 CLAS0004 MESSAGE: None
CAUSE: UDP module stopped.
ACTION: Informative message
26 CLAS0002 MESSAGE: None
CAUSE: Send of IPCControl reply message to NetIPC failed (PARM =
Result code from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
27 CLAS0002 MESSAGE: None
CAUSE: Received unknown message type (PARM = Message function
code).