NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 697
Logging Location Codes Continued
UDP Logging Locations
46 CLAS0003 MESSAGE: None
CAUSE: Attempt to get a path descriptor for the destination in the
datagram send request failed (PARM = Result code returned by
ns_path_resolve).
ACTION: Check the IP address of the destination specified in the
IPCSENDTO call. Also make sure the necessary networks are started. If
problems persist then see Appendix A , “Submitting a CR,” of this
manual.
47 CLAS0003 MESSAGE: None
CAUSE: The attempt to resolve a path failed, most likely due to timeout
during address resolution (PARM = Result code returned by MAP in the
path reply).
ACTION: Check the IP address of the destination given in the
IPCSENDTO call. Also make sure the necessary networks are started. If
OK then see Appendix A , “Submitting a CR,” of this manual.
48 CLAS0002 MESSAGE: None
CAUSE: Attempt to send the reply to CP for a traceoff message failed
(PARM = Result code returned by send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
49 CLAS0002 MESSAGE: None
CAUSE: Attempt to send a reply to CP for a path verify message failed
(PARM = Status returned by send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
50 CLAS0003 MESSAGE: None
CAUSE: Received an inbound ICMP message from IP to be passed to an
application (PARM = ICMP error type and code).
ACTION: Check if application needs to handle this message (i.e., source
quench or destination unreachable).
51 CLAS0002 MESSAGE: None
CAUSE: Failure in attempt to free the inbound buffer on a datagram for
which no SAP is open and no ICMP is sent since it is a broadcast IP
address (PARM = Status returned by bmgr_free_buffer).
ACTION: See Appendix A , “Submitting a CR,” of this manual.