NS3000/iX Error Messages Reference Manual (36923-90043)

708 Chapter22
Logging Location Codes Continued
X.25 Logging Location Codes
ACTION: Check the diagnostic code returned. Verify that all components
are operational.
179 CLAS0005 MESSAGE: None
CAUSE: An outgoing connection request was rejected because the AFCP
connection was closed.
ACTION: Check that the DTC is operational. Try again later.
180 CLAS0005 MESSAGE: None
CAUSE: An incoming IPC connection request was rejected by the DTC
(PARM = Device ID, VC number, cause, diagnostic).
ACTION: Check that the DTC is still operational.
181 CLAS0005 MESSAGE: None
CAUSE: An incoming IPC connection request was rejected by the local
IPC user or application program (PARM = Device ID, VC number,
cause, diagnostic).
ACTION: None. This is an informative message.
182 CLAS0005 MESSAGE: None
CAUSE: An outgoing connection request was rejected because the
security field in the SVC path table specifies that outgoing calls to this
address are not allowed.
ACTION: If outgoing calls to this address are desired, the security field
of the SVC path must be set to OU.
183 CLAS0005 MESSAGE: None
CAUSE: An outgoing connection request was rejected because the
specified facility set for this address key could not be found.
ACTION: Define a new facility set for this configuration, or assign an
existing facility set to the configuration.
184 CLAS0005 MESSAGE: None
CAUSE: An outgoing TCP/IP connection request was rejected because
the connection was requested over a PVC.
ACTION: Modify the configuration to use an SVC.
185 CLAS0003 MESSAGE: None
CAUSE: An outgoing TCP/IP connection request was rejected because
there are no outbound buffers currently available.
ACTION: Try again later, or increase the number of buffers configured.
186 CLAS0005 MESSAGE: None
CAUSE: An outgoing IPC connection request was rejected because the
specified facility set does not exist.