NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 711
Logging Location Codes Continued
X.25 Logging Location Codes
202 CLAS0005 MESSAGE: None
CAUSE: An N-Disconnect packet was sent because an IPC user or
application program called an IPCShutdown intrinsic (PARM = Device
ID, VC number, cause, diagnostic).
ACTION: None. This is an informative message.
203 CLAS0005 MESSAGE: None
CAUSE: An N-Disconnect packet was sent because an IPC user or
application rejected an incoming connection request (PARM = Device
ID, VC number, cause, diagnostic).
ACTION: None. This is an informative message.
204 CLAS0005 MESSAGE: None
CAUSE: An N-Disconnect packet was sent because an IPC user or
application has terminated with an incoming connection request
pending (PARM = Device ID, VC number, cause, diagnostic).
ACTION: None. This is an informative message.
205 CLAS0005 MESSAGE: None
CAUSE: An N-Disconnect packet was sent because an IPC connection’s
inactivity timer expired (PARM = Device ID, VC number, cause,
diagnostic).
ACTION: None. This is an informative message.
206 CLAS0005 MESSAGE: None
CAUSE: An N-Connect request packet was sent.
ACTION: None. This is an informative message.
207 CLAS0005 MESSAGE: None
CAUSE: An N-Connect confirmation packet was sent (PARM = Device
ID, VC number).
ACTION: None. This is an informative message.
208 CLAS0005 MESSAGE: None
CAUSE: An N-Connect confirmation packet was sent (PARM = Device
ID, VC number).
ACTION: None. This is an informative message.
209 CLAS0002 MESSAGE: Internal Error.
CAUSE: A Buffer could not be obtained from the control buffer pool
(PARM = status from Bmgr_get_buffer).
ACTION: See Appendix A , “Submitting a CR,” of this manual.