NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 5 73
NetIPC (SOCKERRS) Error Messages
114 MESSAGE: CREATION OF SOCKET REGISTRY PROCESS FAILED.
CAUSE: Socket registry program missing.
ACTION: Contact your Hewlett-Packard representative for assistance.
116 MESSAGE: DESTINATION UNREACHABLE.
CAUSE: The transport was unable to route the packet to the destination.
ACTION: Notify your operator.
117 MESSAGE: ATTEMPT TO ESTABLISH CONNECITON FAILED.
CAUSE: Protocol module was unable to set up the requested connection.
This may be caused by the remote protocol module not being active.
ACTION: Notify your operator.
118 MESSAGE: INCOMPATIBLE VERSION.
CAUSE: NetIPC software was incompatible with the software being
executed by the remote registry process.
ACTION: Notify your operator.
119 MESSAGE: INCOMPATIBLE VERSION.
CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check your opt record and remove or modify the option.
120 MESSAGE: ERROR IN WINDOW UPDATE THRESHOLD OPTION.
CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check your opt record and remove or modify the option.
124 MESSAGE: ERROR IN WINDOW UPDATE THRESHOLD OPTION.
CAUSE: User error. Entry number of option is either negative or higher
than specified in INITOPT value.
ACTION: Correct and reissue command.
125 MESSAGE: INVALID OPTION DATA LENGTH.
CAUSE: User error. Data length for option is either negative or higher
than specified in INITOPT value.
ACTION: Correct and reissue command.
126 MESSAGE: INVALID NUMBER OF EVENTUAL OPT RECORD
ENTRIES.
CAUSE: Number of option entries is either too high or negative. Either
an internal restriction or a user mistake.
ACTION: Remove the cause by making the number positive or smaller