NS3000/iX Error Messages Reference Manual (36923-90043)

80 Chapter6
Virtual Terminal (VT ERROR) Error Messages
7 MESSAGE: UNEXPECTED/BAD RESPONSE FROM VT.
CAUSE: The VT “partner” on the remote machine could not handle a
request and has generated an unexpected protocol error. This is the
result of Virtual Terminal error 4, 5 or 6 above.
ACTION: One of your commands was probably not executed correctly.
Terminate the session and re-issue the commands. If the problem
persists, verify VT versions and/or submit CR.
8 MESSAGE: VT SERVER NOT ADOPTED.
CAUSE: The VT process could not initialize the environment properly,
probably because of poor timing or a resource shortage.
ACTION: Terminate the session and log on again.
9 MESSAGE: SAVED READ DATA NOT VALID.
CAUSE: Sequencing problem: VT did not have a read request from the
remote system to satisfy your REMOTE command.
ACTION: Reissue your command.
11 MESSAGE: VT TRACE STATE NOT ALTERED.
CAUSE: The trace facility could not be enabled or disabled. When you
are starting the trace, this indicates that the trace file could not be
opened. For trace termination, the file did not close successfully. In
either case there may not be sufficient storage for the file, or the user’s
limit may have been exceeded.
ACTION: Readjust the disk space parameters, and reissue the
command.
12 MESSAGE: VT DATA AREA NOT UPDATED.
CAUSE: Information could not be added to a VT environment-related
table, usually because timing was off or there was a resource shortage.
ACTION: The VT can continue to function; however, it would be best to
terminate the remote session and begin again.
13 MESSAGE: RETRIEVE OF DSLINE DATA FAILED.
CAUSE: The DSLINE table was not accessible to the VT service probably
because of a timing problem in the subsystems. The table entry was not
released.
ACTION: Terminate the remote session.
14 MESSAGE: BUFFER/STORAGE NOT RELEASED.
CAUSE: An internal buffer could not be returned to the buffer pool.
ACTION: If the problem reoccurs, dump the system and see Appendix
A , “Submitting a CR,” of this manual.