NS3000/iX Error Messages Reference Manual (36923-90043)

82 Chapter6
Virtual Terminal (VT ERROR) Error Messages
25 MESSAGE: SET DRIVER MODE FAILED.
CAUSE: The File System did not alter the setting of the driver/terminal
handshake mode.
ACTION: Terminate the remote program.
26 MESSAGE: TERMINAL NOT ALLOCATED.
CAUSE: The terminal could not be allocated for access.
ACTION: Check the MPE configuration and retry the remote session.
27 MESSAGE: SET TERMINAL TYPE FAILED.
CAUSE: The terminal type was not reset as requested.
ACTION: Terminate the remote program and rerun it.
28 MESSAGE: TERMINAL PARITY NOT ALTERED.
CAUSE: The parity setting for reads/writes to the terminal was not
altered.
ACTION: Terminate the remote program, check the terminal's
configuration, and rerun the program.
29 MESSAGE: TERMINAL OPEN FAILED.
CAUSE: The terminal could not be opened for VT access.
ACTION: Use SYSDUMP to verify that your terminal is correctly
configured as a valid MPE terminal.
30 MESSAGE: END OF FILE ENCOUNTERED.
CAUSE: A hardware EOF was set on the terminal.
ACTION: Reestablish your local session.
31 MESSAGE: FATAL INTERNAL ERROR OCCURRED.
CAUSE: The VT could not continue because of a VTS protocol error or a
corrupt data structure.
ACTION: Verify the NS version numbers, and if they are compatible, see
Appendix A , “Submitting a CR,” of this manual.
32 MESSAGE: REMOTE SESSION LOGON FAILED.
CAUSE: The remote logon was started; however, it did not succeed
because the logon timed out, a break was issued during logon, the
remote CI aborted, or communication to the remote system was lost.
ACTION: Reattempt the remote logon.
33 MESSAGE: REMOTE SESSION ABORTED.
CAUSE: Some action on the remote system, probably an operator
command, forced the session to be aborted.