NS3000/iX Error Messages Reference Manual (36923-90043)

92 Chapter8
Remote File Access Error Messages
214 MESSAGE: ILLEGAL USE OF NODE NAME. DS LINE WAS NOT
OPENED WITH A USER :DSLINE COMMAND. (Actual Message
Displayed)
CAUSE: The node does not exist or the specified node name is invalid.
ACTION: Correct the node name.
217 MESSAGE: NOT ENOUGH STACK SPACE FOR RFA. INSUFFICIENT
AMOUNT OF USER STACK AVAILABLE. (Actual Message Displayed)
CAUSE: The MPE PREP command allocated the default ;MAXDATA or
STACK values to the program, which are too small.
ACTION: Run the program again with 2000 additional words allocated
in the ;STACK=stacksize parameter of PREP.
224 MESSAGE: FILE EQUATIONS FOR REMOTE FILE CONSTITUTE AN
INFINITE LOOP. FILE EQUATIONS FOR A REMOTE FILE CONSTITUTE
A LOOP. (Actual Message Displayed)
CAUSE: File equations on the remote machine loop back to the local side
causing reverse RFA.
ACTION: Correct the file equations.
227 MESSAGE: RFA/RDBA COULD NOT FIND OR CREATE A REMOTE
SESSION. RFA/RDBA COULD NOT FIND OR CREATE A REMOTE
SESSION. (Actual Message Displayed)
CAUSE: This error could occur for one of the following reasons:
1. Autologon is not enabled.
2. Autologon is enabled and the logon string specified in the DSLINE
command is incorrect. Remember that if a remote session is already
established, logon strings are ignored.
ACTION: Depending on the cause:
1. Enable autologon (refer to Using NS 3000/iX Network Services), or
establish a VT session using the REMOTE command.
2. Establish a remote session and try again, or use a correct logon
string and try again.
239 MESSAGE: Network Service TRACING MALFUNCTION.
COMMUNICATIONS INTERFACE ERROR. TRACE MALFUNCTION.
(Actual Message Displayed)
CAUSE: Tracing malfunction.
ACTION: See Appendix A , “Submitting a CR,” of this manual.