NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 6 103
Point-to-Point (Router) Network Interface Configuration Screens
Dial ID Protocol Configuration
Dial ID Protocol Configuration
Along with other information, theDial ID Protocol Configuration screen
(#103) provides a means of verifying that the remote node is the
intended remote node and that both local and remote nodes have proper
security access. This screen, shown in Figure 6-6, is displayed when you
press the function key for
[Go To DIAL] at the Protocol Configuration
screen (Figure 6-4). It is also displayed when you type the path name:
@NETXPORT.NI. NIname .PROTOCOL.DIAL
in the Command window of any screen and press the
[Enter] key, where
NIname is the configured point-to-point NI.
Figure 6-6 Dial ID Protocol Configuration Screen
Press the
[Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or updating. Verify that
the data record has been created by checking that the Data flag is set
to Y.
After the data has been updated, press
[Go To SECURITY] to proceed to the
next screen.