NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

106 Chapter6
Point-to-Point (Router) Network Interface Configuration Screens
Security String(s) Configuration
Security String(s) Configuration
The Security String(s) Configuration screen (#110) supplies the security
string required by the Dial ID protocol for the node you are configuring.
(Note that the security string is not required if dial ID protocol is not
enabled.) This screen, shown in Figure 6-7, is displayed if you pressed
the
[Go To Security] function key at the preceding Dial ID Protocol
Configuration screen (Figure 6-6). It is also displayed when you type
the path name:
@NETXPORT.NI.
NIname .PROTOCOL.DIAL.SECURITY
in the Command window of any screen and press the
[Enter] key, where
NIname is a configured point-to-point NI.
Figure 6-7 Security String(s) Configuation Screen
Press the
[Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or updating. You verify
that the data record has been created by checking that the Data flag is
set to Y.