NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

120 Chapter6
Point-to-Point (Router) Network Interface Configuration Screens
Neighbor Gateway Reachable Networks
representing node portion of the address. Note the
network and node portions of all zeros or all ones are
not allowed. These are special values.
The leftmost group of nnn has the following ranges for
each address class:
Class C: 192–223
Class B: 128–191
Class A: 001–126
Default value: None
Related screen:
• NETXPORT.NI.
NIname .PROTOCOL.IP
The network address (network portion of the IP
address) configured in this screen must match the
neighbor gateway IP internet address configured in
the current screen.
Configured
reachable
networks IP
network
address Enter the internet addresses of the remote networks
that can be reached through the gateway whose
network address is configured in the previous field.
You can also designate this gateway as a default
gateway by entering an “at” sign (@) in one of the
Configured reachable networks IP network
address fields. The network will route messages to the
default gateway if it is unable to locate their
destination by any other means. The default gateway
will then attempt to locate the destination.
When specifying reachable networks, entering only the
network portions, and optionally the subnet, of the IP
address (setting the node portion to all zeros) allows
this node to communicate with any other node on the
remote network.
If the remote network is subnetted, you can restrict
communication of this node to particular subnets by
entering the decimal equivalent of those subnets and
including the IP Mask in the IP mask field.