NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

194 Chapter9
FDDI Network Interface Configuration Screens
Address Resolution Protocol (ARP) Configuration
Address Resolution Protocol (ARP)
Configuration
The Address Resolution Protocol (ARP) Configuration screen (#111) in
Figure 9-6 is displayed when you press the
[Go To ARP] function key at the
Protocol Configuration screen (Figure 9-4). It is also displayed when
you type the path name:
@NETXPORT.
NI.NIname .PROTOCOL.ARP
in the command window of any screen and press the
[Enter] key, where
NIname is a configured FDDI NI.
Figure 9-6 Address Resolution Protocol (ARP) Configuration Screen
This screen allows you to configure the information required for the
address resolution protocol (ARP). The ARP protocol exists on a FDDI
network to provide a means of exchanging addressing information
between nodes.
Press the
[Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or modifying. Verify
that the data record has been created by checking the Data flag is set
to Y.