NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

258 Chapter12
Gateway Half Network Interface Configuration Screens
Protocol Configuration
Protocol Configuration
The Protocol Configuration screen (#113) in Figure 12-4 is displayed
when you press the
[Go To PROTOCOL] function key at the Gateway Half
Network Interface Configuration screen (Figure 12-3). It is also
displayed when you type the path name:
@NETXPORT.NI.
NIname .PROTOCOL
in the command window of any screen and press the
[Enter] key, where
NIname is the configured gateway half NI.
Figure 12-4 Protocol Configuration Screen
For the gateway half NI, you must configure the IP protocol. The dial
protocol must be configured only if you have any switched lines.
Choose the protocol to configure and press the corresponding function
key.