NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

262 Chapter12

Gateway Half Network Interface Conﬁguration Screens

Dial ID Protocol Conﬁguration

Along with other protocol information, the Dial ID Protocol

Conﬁguration screen (#103) provides a means of verifying that the

remote node is indeed the intended remote node and that both local and

remote nodes have proper security access. This screen, shown in Figure

12-6, is displayed when you press the

[Go To DIAL] function key at the

Protocol Conﬁguration screen (Figure 12-4). It is also displayed when

you type the path name:

@NETXPORT.NI.

NIname

.PROTOCOL.DIAL

in the command window of any screen and press the

[Enter] key, where

NIname is the conﬁgured gateway half NI name.

Figure 12-6 Dial ID Protocol Conﬁguration Screen

Press the

[Save Data] function key to transfer the data displayed on the

screen to the conﬁguration ﬁle you are creating or updating. Verify that

the data record has been created by checking that the Data ﬂag is set

to Y.