NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 12 269

Gateway Half Network Interface Conﬁguration Screens

Direct Connect Link Conﬁguration

The Direct Connect Link Conﬁguration screen (#105) supplies the

information required to interface a gateway-half NI to a non-dial link

(that is, a leased line or a hardwired connection). This screen, shown in

Figure 12-9, is displayed when you select an NI link name and the link

type DC at the Gateway Half Network Interface Link screen (Figure

12-8) and press the

[Add] or [Modify] function key. It is also displayed when

you type the path name:

@NETXPORT.NI.

NIname

.LINK.

linkname

in the command window of any screen and press the [Enter] key, where

NIname is the conﬁgured gateway half NI, and linkname is the

conﬁgured gateway half NI link.

Figure 12-9 Direct Connect Link Conﬁguration Screen

Press the

[Save Data] function key to transfer the data displayed on the

screen to the conﬁguration ﬁle you are creating or updating. Verify that

the data record has been created by checking that the Data ﬂag is set

to Y.