NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 5 79

LAN Network Interface Conﬁguration Screens

Probe Protocol Conﬁguration

The Probe Protocol Conﬁguration screen (#92) in Figure 5-6 is

displayed when you press the

[Go To PROBE] function at the Protocol

Conﬁguration screen (Figure 5-4). It is also displayed when you type

the path name:

@NETXPORT.NI.

NIname

.PROTOCOL.PROBE

in the command window of any screen and press the

[Enter] key, where

NIname is a conﬁgured LAN NI.

Figure 5-6 Probe Protocol Conﬁguration Screen

This screen allows you to conﬁgure the information required for the

probe protocol. The probe protocol exists on an IEEE 802.3 LAN

network to provide a means of exchanging addressing and naming

information between nodes. Press the

[Save Data] function key to transfer

the data displayed on the screen to the conﬁguration ﬁle you are

creating or updating. Verify that the data record has been created by

checking that the Data ﬂag is set to Y.