NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

106 Chapter6
Point-to-Point (Router) Network Interface Configuration Screens
Network Interface Configuration
Network Interface Configuration
The Network Interface Configuration screen (#112) in Figure 6-2 is
displayed when you press the
[Go To NI] function key at the Network
Transport Configuration Selection screen (Figure 4-2). It is also
displayed when you type the path name:
@NETXPORT.NI
in the Command window of any screen and press the [Enter] key.
Figure 6-2 Network Interface Configuration Screen
Use the fields and function keys of the select screen to perform the
desired action.
• To define a new point-to-point NI configuration, specify the NI name
and the NI type ROUTER; then press the
[Add] function key. The path
for the selected NI name is added to the configuration file, and the
data screen on that path is displayed. Up to 12 NI’s are supported
per system (one NI must be used for loopback).
• To modify an existing NI configuration, specify the NI name; then
press the
[Modify] function key. The data screen on the path for the
specified NI name is displayed.
• To change the name of an existing NI configuration, specify the NI
name and a new name; then press the
[Rename] function key. The
previously configured NI name is replaced and the screen displays